Wash your human hair hairpiece once around 1-multi month is ideal, and furthermore it relies upon the recurrence not place your HD Lace Hair hairpiece near high temperature. Try not to utilize Flat-iron or styler time after time, it will cause you hair hairpiece absence of shiny, dry and simple to broken.
1. Removing the hairpiece tape
Gently remove the hairpiece tape starting from the edges of the hair system.
Spray some adhesive remover first will make it easier for peeling off. Then, use your fingernail to scrap up the edge of the tape to start the peeling
Tips: Remove tape from lace areas will damage the system
2.Soaking the hair system
After removing the Alibonnie hair system, wash your entire head, Alibonniehair, and scalp thoroughly at least twice.
Soak the hair system in a plastic or stainless steel container which is capable of holding a liquid solvent. The time of soaking depends on the type of hair system and adhesive you’re using.
3.Cleaning the hair system
Remove the hair system form the solution and lay it in a sink face up (the hair will be on the bottom).
To clean the lace areas gently brush the swollen adhesive reside with a fingernail brush to loosen and break it free.
To clean the skin areas use a teaspoon to scrap any excess residue off with gentle, short vertical strokes.
After getting most of the excess residue off, put the hair system back into the container full of solvent for 2-4 more minutes.
Tip: Mirror slide is a very helpful tool for lace bases. Do not use it with poly/skin bases though, as the sliding can cause them to stretch.
4. Rinsing the hair system
Take the system from the solvent and put it into the sink. Squirt a liberal amount of hand dishwashing liquid onto the base while it is still dripping wet with solvent. Any remaining adhesive residue will have lost all tack.
Slowly and carefully glide the fingernails brush across the edge of the base and out through the air. All the remaining adhesive residue should slide off easily. After a few minutes of brushing, rinse your system with high-pressure lukewarm water down through the base. Repeat this step a second time.
If there I still adhesive residue in the hair system, you may not soak it in the solvent long enough. You need to repeat step 2.
Now, your hair system should be clean and clear of any adhesive residue. Wipe it with alcohol and you are now ready to reattach and begin to wear the fresh system.
Everything is very open with a really clear explanation of the issues. It was really informative. Your website is very useful. Many thanks for sharing!
Itís hard to find well-informed people on this subject, but you seem like you know what youíre talking about! Thanks